Water Tube Type Boiler

Summary

The water tube boiler has the all-membrane wall structure and

has 3Pass for the small capacity lower than 5T/Hr and 2Pass or

3Pass for the capacity above 6T/Hr and with a preheater and

a fuel economizer equipped, it maximizes heat efficiency

by minimizing the thermal loss of the exhaust gas and

radiant heat and also has a beautiful exterior.

Features

• Water tube steam boiler with membrane wall system is designed to keep the wall under staurated steam temperature by minimizing radiant heat loss and to maximize the efficiency of heat by a pressed combustion system.
• It has high durability with the perfect design and high quality materials.
• This design was made in accordance with the calculation of minimum maintenance temperature of heating surface. It solves the problem of short life time of air preheater caused by the erosion of low temperature. In result, the durable time was prolonged.
• As it has membrane wall system, there is no gas leaking. It is easy not only to repair with no establishment of castable but also to clean and remove soot.
• Special steam separator was used to minimize foaming and priming. This prevented low productivity resulted from the erosion of water hammer pipe and wet steam.
• With the proper arrangement of vaporization pipe, downcast pipe and banks of tubes, waterish smoothly circulated and it is very safe because of no shake of the water inside boiler pipes.
• It is also designed to lower the loss of ventilation, which made it possible to reduce the maintenance cost and the operation noise.

Usage : Synthetic fiber, Paper manufacturing, Beer alcool factories, Food processing factories, Rubber factories, Apartments and factories to need medium or large volume of steam with high pressure such as petroleum chemistry plant.

Spectifications

P& DIAGRAM